Time Setup / Lithium Battery - Panasonic SR-ZX185 Manuel D'utilisation

Time setup / Lithium battery

Connect the power plug. Press
1
beep sound. The time shows in the LCD starts to blink.
2 Press or
Keeping the button pressed will make setting faster.
• 24:00 is replaced by 0:00.
• Error may occur in the Timer function if the current time has not been set properly.
• The time cannot be setup during operating state.
3
The time will be automatically set after leaving about 5 seconds. (LCD stops blinking).
Power source for the clock
When unplugged
The internal
lithium battery is
fully utilized.
When plugged
The power supply
source is fully
utilized.
6
SR-ZX_ZG185_105_OIB_US_EN__cover modified_2210.indd 6 SR-ZX_ZG185_105_OIB_US_EN__cover modified_2210.indd 6
Time setup
or button for more than one second, then release the button after a
button to set the time (1 minute increment).
Lithium battery
Battery Replacement
If lithium battery is fully utilized, please contact
authorized service center for replacement.
The life time of battery is around 5 years (At
20°C room temperature and plugged in 12 hours
each day).
When the battery is consumed, the following
phenomenon will happen:
• The clock becomes vague or disappears.
• Memory of preset time is lost.
• The clock can be used again when power plug
is connected.
(The clock resetting is required).
Note: Do not put the lithium battery into the fi re, do
not recharge, disassemble or heat the battery, etc.
This product contains a CR Coin Cell Lithium
Battery which contains Perchlorate Material
– special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
10/28/2015 7:17:48 PM 10/28/2015 7:17:48 PM