Bosch BSG7 Série Notice D'utilisation page 41

Cleaning the motor protection filter
The motor protection filter should be cleaned regularly by
knocking out the dirt and rinsing.
24
Figure
Open the dust bag compartment lid (see Figure 22).
Pull out the motor protection filter in the direction of the
arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter should be
rinsed.
The filter must then be left to dry for at least 24 hours.
After cleaning, slide the motor protection filter into the
vacuum cleaner and close the dust bag compartment lid.
Replacing the exhaust filter
You must replace the exhaust filter in your vacuum cleaner
once a year.
Replacing the micro-hygiene filter
25*
Figure
Open the dust bag compartment lid (see Figure 22).
Release the filter holder by pressing the locking tab in the
direction of the arrow
Remove the foam filter and micro-hygiene filter.
Insert the new micro-hygiene filter and foam filter into the
filter holder.
Insert the filter holder into the vacuum cleaner and clip
into place.
Replacing the micro active carbon filter
26*
Figure
Open the dust bag compartment lid (see Figure 22).
Release the filter holder by moving the locking lever in
the direction of the arrow.
Remove the micro active carbon filter.
Insert the new micro active carbon filter into the vacuum
cleaner and clip into place.
Replacing the HEPA filter
27*
Figure
Open the dust bag compartment lid (see Figure 22).
Release the HEPA filter by pressing the locking tab in the
direction of the arrow and remove it from the vacuum
cleaner (see Figure 25).
Insert the new HEPA filter and clip into place.
If you have used the vacuum cleaner for fine dust particles,
clean the motor protection filter by knocking out the dirt
and, if necessary, replace the micro hygiene filter, active
carbon filter or HEPA filter.
40
Care
Always switch off the vacuum cleaner and disconnect the
power cord from the mains before cleaning the vacuum
cleaner.
The vacuum cleaner and plastic accessories can be cleaned
with a commercial plastic cleaner.
Do not use a scourer, glass-cleaning agent or all-
!
purpose cleaning product.
Never immerse the vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned with a
second vacuum cleaner or simply wiped with a dry cloth or
dusting brush.
Subject to technical modifications.