Attaching The Carrying Cord; Inserting And Changing The Battery - Leica RANGEMASTER CRF 1600 Notice D'utilisation

ATTACHING THE CARRYING CORD

Feed the small loop on the carrying cord through
the eyelet (4) on the housing of the LEICA RANGE-
MASTER CRF 1600. Then thread the end of the cord
through the small loop and pull tight, so that the
resulting loop is securely around the eyelet on the
housing.

INSERTING AND CHANGING THE BATTERY

The LEICA RANGEMASTER CRF 1600 is powered by
a 3 Volt lithium battery (e.g. Duracell DL CR2, Ucar
CR2, Varta CR2, or other CR2 types).
1. Open the cover (6) on the battery compartment
(7) by turning it anticlockwise.
2. Insert the battery so that the positive contact
goes in first (as shown by the markings in the bat-
tery compartment).
3. Close the cover again by turning it clockwise.
22