Timer Function; Care And Descaling - Coffeemaxx 2 Go Thermo Star Mode D'emploi

11. Once the brewing procedure has ended, you can remove the thermal cup from the
device.
12. Press the Start/Stop button once to switch the device to stand-by mode. The
Start/Stop control lamp will light up for a short period of time and the time which is set
will then appear on the display.
13. Clean the device after each use as described in the "Care and Descaling" section.

Timer function

The coffee machine has an automatic coffee brewing function. You can select a starting time
at which the coffee machine automatically starts the brewing procedure. To do so, take the
following steps.
1. Fill the coffee machine in the manner described in the "Brewing coffee" sections.
2. Now set the automatic starting time by pressing the PROG button until the time display
fl ashes.
3. Set the automatic starting time using the STD (hour) and MIN (minute) buttons.
4. Then press the PROG button to confi rm your time entry.
5. The green control lamp will light up and indicate to you that you have switched on the
timer function.
6. The coffee machine now starts the brewing procedure at the set time. The green PROG
control lamp will go out and the red Start/Stop control lamp will light up and indicate
to you that the brewing procedure is beginning.
7. You can also start the brewing procedure at any time before the set starting time. To do
this, simply press the Start/Stop button once. The red Start/Stop control lamp will
light up and indicate to you that the brewing procedure has been started.
8. Once the brewing procedure has ended, you can remove the thermal cup from the
device.
9. Press the Start/Stop button once to switch the device to stand-by mode. The
Start/Stop control lamp will light up for a short period of time and the time which is set
will then appear on the display.
10. Clean the device after each use as described in the "Care and Descaling" section.

Care and Descaling

PLEASE NOTE!
❐ Never immerse the device, the cable or the plug in water or other liquids.
❐ Danger of scalding! First allow the device to cool down suffi ciently before cleaning it.
❐ Do not use corrosive or abrasive cleaning agents to clean the device. These could
damage the surface.
1. Empty the fi lter after every use. Dispose of the old coffee grounds in the household
rubbish bin.
2. Clean the fi lter insert, the permanent fi lter and the thermal cup with hot water and a
little mild detergent if necessary. Let all parts dry well before storing them away.
01132_DE-GB-FR-NL_V2.indb 19 01132_DE-GB-FR-NL_V2.indb 19
19
18.03.11 13:25 18.03.11 13:25