Commissioning And Making Basic Settings; Brewing Coffee - Coffeemaxx 2 Go Thermo Star Mode D'emploi

Commissioning and making basic settings

1. Place the device on a level, fi rm and heat-resistant surface.
2. Connect the device to a mains socket that has been properly installed.
3. The preset time "00:00" will fl ash on the display.
4. Set the time using the STD (hours) and MIN (minutes) buttons.
5. Then press the PROG button to confi rm your entry. The display will then stop fl ashing.

Brewing coffee

1. Use the thermal cups which are supplied with the product to fi ll the device, as this will
help to ensure you do not overfi ll the water reservoir.
2. Unscrew the lid of the thermal cup and fi ll the thermal cup with tap water at room
temperature.
3. Open the water reservoir cover and fi ll the water reservoir.
6. Place the permanent fi lter into the fi lter insert and fi ll it with the necessary amount of
coffee powder.
7. Make sure that the handle of the fi lter insert and of the permanent fi lter is folded down
so that the fi lter compartment cover can close correctly.
8. Then close the water reservoir cover.
9. Press the Start/Stop button twice to switch on the device and start the brewing
procedure. The device is switched on when the red Start/Stop control lamp is lit up
and the word "ON" appears on the display.
10. When the brewing procedure comes to an end, the Start/Stop control lamp goes out
and a cup symbol on the display indicates to you that your coffee is ready to drink. If you
wish to stop the brewing procedure before it ends automatically, simply press the
Start/Stop button. The brewing procedure will be interrupted directly.
01132_DE-GB-FR-NL_V2.indb 18 01132_DE-GB-FR-NL_V2.indb 18
4. Screw the lid back onto the thermal cup. Open the drinking
cap and place the cup beneath the coffee discharge open-
ing. It is essential for the drinking cap to be open in order to
open the non-drip valve. If the drinking cap is not open, the
water cannot fl ow out of the fi lter compartment and in the
worst-case scenario it will overfl ow!
5. Open the fi lter compartment and insert the fi lter insert.
Make sure that you place the fi lter insert into the fi lter
compartment correctly. The spring for opening the non-drip
valve must be pointing in the direction of the water
reservoir.
18
18.03.11 13:25 18.03.11 13:25