Before Initial Use; Unpacking; Cleaning; Use - Coffeemaxx 2 Go Thermo Star Mode D'emploi

Before Initial Use

Before you can use the device, you must:
• unpack the items supplied,
• clean the device.

Unpacking

PLEASE NOTE!
❐ Keep children and animals away from the packaging material. There is a danger of
suffocation!
Unpack all parts and check the scope of supply for completeness (see "Scope of Supply"
section); also check for transport damage. If you fi nd any damage to the components, do not
use them (!), but contact our customer service department.

Cleaning

PLEASE NOTE!
❐ Do not use corrosive or abrasive cleaning agents to clean the device. These could
damage the surface.
1. Clean the fi lter insert, the permanent fi lter and the thermal cup with hot water and a
little detergent if necessary.
2. Then dry all parts and place them in the coffee machine.
3. We recommend that, prior to fi rst use, you operate the device three times with just
water (no coffee) to fl ush through all the lines etc. Before fi rst using the device, please
also note the information in the "Use" section.

Use

PLEASE NOTE!
❐ Do not overfi ll the water reservoir. Never pour water into the water reservoir above
the MAX marking.
❐ Never operate the device without water.
❐ RISK OF SCALDING! Never open the fi lter compartment during the brewing
procedure. Hot steam may emerge.
❐ The device has overheating protection which prevents the device from being switched on
again directly after a brewing procedure for safety reasons. After a brewing procedure,
you should therefore wait for a few minutes until the device has cooled down before you
start another brewing procedure.
❐ The coffee machine has a non-drip valve which only works in combination with the
thermal cups which are supplied with the product. Do not attempt to place other vessels
beneath the coffee discharge opening.
01132_DE-GB-FR-NL_V2.indb 17 01132_DE-GB-FR-NL_V2.indb 17
17
18.03.11 13:25 18.03.11 13:25