ero electronic PKC Mode D'emploi page 130

RELATIVE GAIN OF THE SECONDARY OUTPUT
CALCULATION BY SMART ALGORITHM ............. 96
SETPOINT HIGH LIMIT .......................................... 83
SETPOINT LOW LIMIT ........................................... 82
SERIAL LINK DEVICE ADDRESS .......................... 92
SERIAL LINK BAUDE RATE .................................. 92
SERIAL LINK BYTE FORMAT ................................ 92
SERIAL INTERFACE PROTOCOL ......................... 92
SECONDARY CONTROL OUTPUT
HIGH LIMIT ............................................................. 82
SECONDARY CONTROL OUTPUT
LOW LIMIT .............................................................. 82
SECONDARY CONTROL OUTPUT
MAX RATE OF RISE ............................................... 82
SECONDARY OUTPUT CYCLE TIME ................... 82
SERVO MOTOR DEAD BAND ............................... 81
SERVO MOTOR TRAVEL TIME ............................. 80
Run time group 2 - SMART ENABLE/DISABLE ..... 72
SMRT ENABLED OR DISABLED ........................... 72
MAIN SETPOINT .................................................... 71
SETPOINT 2 ........................................................... 71
SETPOINT 3 ........................................................... 71
SETPOINT 4 ........................................................... 71
Run time group 7 - SERIAL LINK PARAMETER .... 92
Xkc-B-A0.p65 3
2 rue René Laennec 51500 Taissy France
Fax: 03 26 85 19 08, Tel : 03 26 82 49 29
Run time group 1 - SETPOINT VALUES ................ 71
DERIVATIVE TIME ................................................. 79
INTEGRAL TIME ..................................................... 78
MAX VALUE OF INTEGRAL TIME VALUE
CALCULATED BY THE SMART ALGORITHM ....... 96
MIN VALUE OF INTEGRAL TIME VALUE
CALCULATED BY THE SMART ALGORITHM ....... 96
TIMEOUT FOR SOFT START ................................ 83
B. 3
15/12/99, 15.48
E-mail:hvssystem@hvssystem.com
Site web : www.hvssystem.com