LEMAN SST256 Manuel D'utilisation page 65

4.3.3 INSTALL BLADE GUARD AND HOSE
Tools Required for Assembly:
- Phillips Screwdriver
WARNING
Please tighten the hose clamps absolutely. Otherwise,
may cause machine wobble orserious injury to the
operator or other persons.
- Put the blade guard into the slot on riving knife B, and
lock it.
- Connect C and E with the clamps D.
4.3.4 INSTALL SLIDING TABLE
Tools Required for Assembly:
- Wrench 16mm
- Put the sliding table to the frame top, and use 6, 7, 8 to
lock the sliding table.
- Install the handle C to sliding table with 4, 5.
- Install Plate pusher A to sliding table with 1, 2, 3.
4.3.5 INSTALL SQUARE SLIDING TABLE
Tools Required for Assembly:
- L wrench 6mm
- Put the square sliding table into the sliding table A, and
then insert C into B and E.
- Lock square sliding table to A with 1, 2.
4.3.6 INSTALL TELESCOPIC FENCE
- Put the pin C of telescopic fence A into the hole which is
on the square sliding table.
- Micro-adjust he position pin D to get accurate 90degree
positon for quick stop limit.
- When angle adjustment finish, tighten the lock clamp E.
C
D
B
4 5
C
6
7
8
B
C
D
GB
-11-
B
E
Fig.4.3.3
A
Fig.4.3.4
A
2
1
E
D
Fig.4.3.5
A
E
B
Fig.4.3.6
A
1
2
3
C