Installation Site; Unpacking - Leica DMIL Mode D'emploi

Installation site

The microscope should be operated in a dust-
free room which is also free from oil, chemical
fumes, and excessive humidity. Major tem-
perature fluctuations, direct sunlight, and
vibration should be avoided because they can
affect measurements and photomicrography.
Ambient conditions:
Temperature
Relative humidity
In warm and humid climates, microscopes
require special care to prevent fungal growth.
For additional instructions, please refer to
chapters "Maintenance" and "Storage".
Attention!
Lamp housings* and power units* must be
located at least 10 cm away from the wall and
combustible objects.
10 – 36 °C
0 – 80 % up to 30 °C

Unpacking

Please compare the delivery carefully with the
packing note, delivery note or invoice. We
strongly recommend that you keep a copy of
these documents with the manual so that you
have the proper information on the time and
scope of delivery at a later time when ordering
more equipment or when the microscope is
serviced. Please make sure that no small parts
are left in the packing material. Some of our
packing material has symbols that indicate that
it can be recycled in an environmental-friendly
manner.
Note
Keep the packing material for the purpose of
storage and transport of the microscope and its
accessories.
Attention!
Avoid touching the surface of the optics lens.
If finger prints are left on the glass surfaces,
use a soft leather or linen cloth to remove
them. Even minute traces of perspi-ration
from fingers can corrode the surfaces of
optical instruments in a very short time. For
additional instructions, please refer to
chapters "Maintenance" and "Cleaning".
15