Assembly An Description Of Components; Site - Leica DMLS Mode D'emploi

Assembly and description of components
Unpacking Documents
Please compare the delivery carefully with the
packing note, delivery note or invoice. We
strongly recommend that you keep a copy of
these documents with the manual, so that you
have information on the time and scope of
delivery later when ordering more equipment or
when the microscope is serviced. Make sure
that no small parts are left in the packing
material. Some of our packing material has
symbols indicating environmental-friendly re-
cycling.
!
Attention:
Imp ortant note! When taking the microscope out
of its packing and putting it onto the desk take
care not to damage the sensitive vibration-
damping feet on the bottom of the microscope.
Fig. 1 Assembly tools
1 3 mm Allen key
2 2.5 mm Allen key (short)*
3 1.5 mm centering keys*
4 2 mm centering keys*
4 for UCL/UCLP condenser
5 Crosstip screwdriver*
8
All manuals and user guides at all-guides.com
3
5 4
1 2
Attention:
Do not connect the microscope and pe-
ripherals to the mains yet! (→ p. 18 – 21).
Installation site
!
Attention:
Make sure that the workplace is free from oil
and chemical fumes. Vibrations, direct sunlight
and major temperature deviations have a
negative effect on measurements and photo-
micrography. It is important to have a stable
desk of the right height (70 – 80 cm). This and an
ergonomically designed chair which can be
adjusted in several positions are the basic
prerequisites for fatigue-free microscopy.
Fig. 2 The main microscope
components
* not part of all outfits
Eyepieces
Tube
Intermediate system
Objective
nosepiece
Object
stage
Condenser
Micro-
scope
stand
Base
Light source