Mounting A Linear Drive Unit; Integrated Guideways - THOMSON WM60-370ZRT Instructions De Montage Et De Maintenance

Mounting a linear drive unit

4 Mounting a linear drive unit
4.1

Integrated guideways

The linear drive unit is fixed by means of mounting brackets (KAO brackets) fitted to the
aluminium tubular section. The tubular section must always be fastened to level surfaces.
Standard parallelism <0.01mm per 100mm.
The linear drive unit must be aligned to comply with the requirements of the intended use.
The following procedure is suggested:
1. Loosen the relevant mounting bracket.
2. Align the linear unit and/or mounting bracket accordingly, and refasten. If necessary:
3. Loosen other mounting brackets and repeat the procedure.
Full load moment is possible only when the distance between the KAO brackets
Because the load when placed on top increases the deformation of the aluminium profile, the
distance between the KAO brackets must be reduced in this case (for KAO tightening
torques, see table in Chapter 10 "Technical Data").
Fig. 3:
28
42/08
750mm.
WIESEL POWERLine ZRT
®