Replacing The Cover Strip; Worn Out Cover Strip Still In Place - THOMSON WM60-370ZRT Instructions De Montage Et De Maintenance

Maintenance
8.2

Replacing the cover strip

8.2.1

Worn out cover strip still in place

1. Fig.8: Move the sliding carriage to the backward end position (movable bearing side).
2. Loosen the threaded studs on top of the fixed-bearing housing.
3. Loosen the threaded studs on top of the movable bearing housing.
4. Pull the old cover strip with tensioning plate out of the fixed-bearing housing towards the
movable bearing until it is about 20 cm from the sliding carriage (Attention: do not pull it
through the carriage!). Take care that the tensioning plates do not fall into the tubular
section while you are removing them from the fixed-bearing housing or cover plate.
5. Remove the old cover strip from the tubular section between fixed bearing and carriage
and remove grease from the upper side.
6. Join the old and new strips flush between carriage and fixed bearing, and connect them
with adhesive tape on the upper side.
7. Clip old and new strip into the tubular section, and move the carriage (by hand, if
possible) towards the fixed bearing, until about 20 cm of the new strip is visible at the
other end of the sliding carriage.
8. Remove the old cover strip and adhesive tape from the new cover strip, and dispose of
them in an environmentally suitable way.
9. Fasten the new covering strip in the movable-bearing housing with tensioning plate and
threaded studs.
10. Pull the new strip on the movable-bearing side until it sits completely on the tubular
section.
11. Clip the cover strip manually into the tubular section, starting at the fixed-bearing end.
12. Cut off cover strip with an overlap of 8-9 mm (depth of insertion pouch in cover plate
10 mm).
13. Insert the end of the cover strip on the movable-bearing side through the cover plate
simultaneously clipping it into the tubular section, starting at the sliding carriage.
Fig. 8:
36
42/08
WIESEL POWERLine ZRT
®