Commissioning - THOMSON WM60-370ZRT Instructions De Montage Et De Maintenance

Commissioning

5 Commissioning
The WIESEL POWERLine ZRT
movements with great force. Structures in the sliding carriage can lead to injuries, e.g.
crushing of body parts, or to damage through collision with other parts of the system.
Exercise the utmost caution during first start-up.
The acceleration and retardation of the linear drive unit can cause transported load to come
loose and be thrown off.
The manufacturer's information for any supporting equipment used must be checked
against the weight and acceleration data!
The linear drive units must not be put into service until the machinery into which it is to be
incorporated fulfils all the provisions of the EC directive relating to machinery, the harmonised
standards, European standards or the applicable national standards.
To comply with the regulations concerning electromagnetic compatibility of machines,
care must be taken in installing them. Therefore the Standards EN 50 081-2 and
EN 50 082-2 should be observed to avoid electromagnetic interference.
The electrical installation must be carried out by an EMC expert.
Pay attention to the notes in Chapter 4 "Mounting a linear drive unit" on correct, safe
preparation of your linear drive unit for first operation.
Before the first power-on, make sure that the inductive and/or mechanical limit switches are
functioning properly. First cause the assembled linear drive unit to move through its complete
range of travel so slowly that you can stop the movement in time to prevent a possible
collision.
Only after a collision test has been carried out may the system be tested at full speed.
32
42/08
®
mechanical linear drive units can carry out fast linear
WIESEL POWERLine ZRT
®