Electrolux EUT1040AOW Notice D'utilisation page 25

Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
Water flows on the floor.
Temperature cannot be
set.
Door is misaligned or inter‐
feres with ventilation grill.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The FastFreeze function is
switched on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
Food products are not
wrapped properly.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The FastFreeze function is
switched on.
The appliance is not level‐
led.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
ENGLISH
Solution
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion".
Refer to "Closing the door".
Wrap the food products
better.
The compressor starts af‐
ter a period of time.
Attach the melting water
outlet to the evaporative
tray.
Switch off FastFreeze
manually, or wait until the
function resets automati‐
cally to set the tempera‐
ture. Refer to "FastFreeze
function"
Refer to "Levelling".
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
25