Storing The Trimmer After Use; Repair Service; Spare Parts; Waste Disposal And Environmental Protection - IKRA AHS 4054 Mode D'emploi

sharpened cutting blade should be covered by the blade
cover. The blades cannot be sharpened by the user
without opening the equipment and the safety mecha-
nism. Resharpening of the blades can therefore only be
carried out at a specialist workshop.
2) Changing the blades
Only correct installation of the blades will guarantee
problem-free operation and function of the above men-
tioned safety feature of the blades. Changing of the
blades should therefore only be carried out at a special-
ist workshop.
3) Blade safety rail (Fig. 10)
The cutting blade set back from the blade housing reduc-
es the risk of injuries due to unintentional body contact.

Storing the trimmer after use

The hedge shears must be stored such that there is
no danger of injuries being caused to persons by the
cutting blades!
Important note: The shearing blades should be cleaned
after each use (see also Section Maintenance).This will
considerably increase the service life of the device. Please
use a lubricator that is not harmful to the environment,
e. g. our service spray. Then put the shears in their case
with the cutting blades first.

Repair service

Repairs to electric power tools should only be carried out
by specialist electrical personnel.

Spare parts

Please contact our service department if you need ac-
cessories or spare parts.
When working with this machine, do not use spare parts
other than those recommended by us. Using spare parts
not recommend by us can result in serious injuries to per-
sons or damage to the machine.
The following information should be provided when
ordering spare parts:
• Type of machine
• Item number of the machine

Waste disposal and environmental protection

Dispose of the machine properly after it is worn out. Dis-
connect the mains cable in order to prevent misuse. Do
not dispose of the machine with the household waste. In
the interest of environmental protection, take it to a coll-
ection point for electric machines. Your responsible local
authority can provide you with addresses and operating
times. Also take the packaging materials and worn out
accessories to the appropriate collection points.
Only for EU countries
Do not discard electric tools in the household
waste!
In accordance with European Directive 2012/19/EC on
waste electrical and electronic equipment and its im-
plementation in national law, waste electric tools must
be collected separately for environmentally-compatible
re-use.
Recycling alternative to the return invitation:
Instead of returning the electric equipment, the owner is
alternatively obligated to take part in the proper recycling
in the case of relinquishment of ownership. The waste
equipment can also be taken to a collection facility which
disposes of it in the sense of the national recycling ma-
nagement and waste acts. This does not pertain to the
accessory parts and auxiliary equipment without elec-
trical components accompanying the waste equipment.

Warranty

For this tool, the company provides the end user - inde-
pendently from the retailer's obligations resulting from
the purchasing contract - with the following warranties:
The warranty period is 60 months beginning from the
hand-over of the device which has to be proved by
the original purchasing document. For commercial use
and use for rent, the warranty period is reduced to 12
months. Wearing parts, rechargeable batteries and
defects caused by the use of non fitting accessories,
repair with parts that are not original parts of the manu-
facturer, use of force, strokes and breaking as well as
mischievous overloading of the motor are excluded from
this warranty. Warranty replacement does only include
defective parts, not complete devices. Warranty repair
shall exclusively be carried out by authorized service
partners or by the company's customer service. In the
case of any intervention of not authorized personnel, the
warranty will be held void.
All postage or delivery costs as well as any other subse-
quent expenses will be borne by the customer.
GB-8