Publicité
Les langues disponibles
Les langues disponibles
Dust nozzle (optional accessory)
When you wish to perform clean cutting operation, use
the dust nozzle. Install the dust nozzle on the router base
using the two screws and connect a vacuum cleaner to
the dust nozzle.
OPERATION
Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Lower the tool body and
move the tool forward over the workpiece surface, keep-
ing the tool base flush and advancing smoothly until the
cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
1
2
3
1. Workpiece
3. View from the top of the
tool
NOTE:
•
Moving the tool forward too fast may cause a poor
quality of cut, or damage to the bit or motor. Moving
the tool forward too slowly may burn and mar the
cut. The proper feed rate will depend on the bit size,
the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece, it is
advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look
as well as enable you to check dimensions.
•
When using the straight guide, be sure to install it
on the right side in the feed direction. This will help
to keep it flush with the side of the workpiece.
003258
1. Dust nozzle
1
2. Hose of vac-
uum cleaner
3. Screws
2
3
2
4
4
2. Bit revolving direction
4. Feed direction
Straight guide
The straight guide is effectively used for straight cuts
when chamfering or grooving.
To install the straight guide, insert the guide bars into the
holes in the tool base. Adjust the distance between the
bit and the straight guide. At the desired distance, tighten
the wing bolts to secure the straight guide in place.
1
2
001984
When cutting, move the tool with the straight guide flush
with the side of the workpiece. If the distance (A)
between the side of the workpiece and the cutting posi-
tion is too wide for the straight guide, or if the side of the
workpiece is not straight, the straight guide cannot be
used. In this case, firmly clamp a straight board to the
workpiece and use it as a guide against the router base.
Feed the tool in the direction of the arrow.
A
Templet guide (optional accessory)
6
003259
003260
1. Straight guide
2. Guide bar
3. Wing bolt
3
003261
003262
Publicité
