Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Ending a programme
When the baking process has been completed,
you will hear ten beeps and the display
0:00. At the end of the programme, the appliance
automatically changes to a keep-warm mode for
up to 60 minutes.
NOTE
►
This does not apply to programmes 6, 7 and
11.
In this mode, warm air circulates inside the appli-
GB
ance. The keep-warm function can be ended early
by keeping the Start/Stop button
a beep is heard.
DANGER! ELECTRIC SHOCK!
►
Before opening the appliance lid
nect the power plug from the socket. The
appliance should always be disconnected
from the power grid when not in use!
Taking out the bread
Always use pot holders or oven gloves when re-
moving the hot baking mould
mould
tilted over a grill tray and shake it lightly
until the bread slides out of the baking mould
If the bread does not slip off the kneading blades
carefully remove the kneading blades
supplied kneading blade remover
NOTE
Do not use any metal objects that could cause
scratches on the non-stick coating. Rinse the
baking mould
removing the bread. This will help prevent the
kneading blades
shafts.
TIP
If you remove the kneading hooks
dough after the last kneading process, the bread
will not be torn open when removing it from the
baking mould
78
pressed until
, discon-
. Hold the baking
.
with warm water directly after
becoming stuck on the drive
from the
.
■
Press the Start/Stop button
the programme at the very start of the baking
phase or, pull the power plug out of the socket.
indicates
Ensure that you replace the power plug within
10 minutes so that the baking process can be
continued.
■
Open the appliance lid
baking mould
remove the dough and then pull out the knead-
ing hooks
■
Replace the dough in the back baking mould
Replace the baking mould
appliance lid
■
Put the power plug into the socket if necessary.
The baking program continues from where it
was stopped.
Allow the bread to cool for 15–30 minutes before
eating it.
Before cutting the bread, always check to ensure
that the kneading blades
from it.
Error messages
■
If the display
gramme has been started, it indicates that the
.
temperature in the bread maker is still too high.
,
Stop the programme and remove the power
using the
plug. Open the appliance lid
machine to cool down for 20 minutes before
reusing it.
■
If a new programme cannot be started directly
after the bread maker has completed a baking
process, it means the appliance is still too hot.
In this case, the display panel reverts to the
default setting (programme 1). Open the ap-
pliance lid
down for 20 minutes before reusing it.
NOTE
►
Do not attempt to reuse the appliance until it
has cooled itself down. This functions only in
programme 12.
briefly to pause
and remove the
. With floured hands, you can
.
and close the
.
have been removed
shows "HHH" after the pro-
and allow the
and allow the machine to cool
SBB 850 B1
.
Publicité
Chapitres
Table des Matières
