Bosch PBH 2800 RE Mode D'emploi page 21

OBJ_BUCH-318-001.book Page 21 Monday, April 23, 2007 12:20 PM
Adjusting the Drilling Depth on the Dust Extrac-
tion Attachment (see figure L)
The required drilling depth X can also be adjusted
when the dust extraction attachment is mounted.
Insert the SDS-plus drilling tool to the stop into the
SDS-plus tool holder 3. Otherwise, the movability of the
SDS-plus drilling tool can lead to incorrect adjustment
of the drilling depth.
Loosen the wing bolt 30 on the dust extraction attach-
ment.
Without switching the power tool on, apply it firmly to
the drilling location. The SDS-plus drilling tool must
face against the surface.
Position the the guide pipe 31 of the dust extraction
attachment in its holding fixture in such a manner that
the head of the dust extraction attachment faces
against the surface to be drilled. Do not slide the guide
pipe 31 further over the telescopic pipe 29 of the dust
extraction attachment than required, so that as much as
possible of the scale 29 on the telescopic pipe remains
visible.
Retighten the wing bolt 30 again. Loosen the clamping
screw 27 on the depth stop of the dust extraction
attachment.
Move the depth stop 28 on the telescopic pipe 29 in
such a manner that the clearance X shown in the figure
corresponds with the required drilling depth.
Tighten the clamping screw 27 in this position.
Operation
Starting Operation
Observe correct mains voltage! The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Power tools marked with 230 V can also be
operated with 220 V.
Setting the Operating Mode
The operating mode of the power tool is selected with
the mode selector switch 12.
Note: Change the operating mode only when the
machine is switched off! Otherwise, the machine can
be damaged.
To change the operating mode, push the release but-
ton 11 and turn the mode selector switch 12 to the
requested position until it can be heard to latch.
1 619 929 781 • 23.4.07
PBH 2800 RE/PBH 2900 FRE/PBH 3000 FRE Set
Position for drilling without impact in
wood, metal, ceramic and plastic as
well as for screwdriving and thread cut-
ting.
Position for hammer drilling in con-
crete or stone
Vario-Lock position for adjustment of
the chiselling position
The mode selector switch 12 does not
latch in this position.
Position for chiselling
PBH 3000-2 FRE
For the operating modes hammer drilling, Vario-Lock
and chiselling, the gear selector 13 must be set to
1st gear.
Position for drilling without
impact (1st gear) in wood,
metal, ceramic and plastic as
well as for screwdriving and
thread cutting
Position for drilling without
impact (2nd gear) in wood,
metal, ceramic and plastic
Position for hammer drilling
in concrete or stone
Vario-Lock position for adjust-
ment of the chiselling position
The mode selector switch 12
does not latch in this position.
Position for chiselling
Reversing the Rotational Direction
(see figure M)
The rotational direction switch 10 is used to reverse the
rotational direction of the machine. However, this is not
possible with the On/Off switch 8 actuated.
Right rotation: Push the rotational direction
switch 10 rightward to the stop.
Left rotation: Push the rotational direction switch
10 leftward to the stop.
Set the direction of rotation for hammer drilling, drilling
and chiselling always to right rotation.
English | 21