Klein Tools TDR Ranger VDV501-090 Mode D'emploi page 11

2. Note that the connection to the cable to be tested should be as
short as possible to ensure the Ranger™ TDR does not see the
impedance continuity at the attachment point as a fault.
3. Determine the correct NVP value for the cable to be tested as
instructed in Obtaining NVP Values section.
4. Set the NVP value as instructed in Setting NVP Values section.
5. Turn the unit on by pressing the Power button.
6. Change the unit of measurement if necessary by pressing and
holding the Memory and Calibration buttons at the same time.
7. Press the Test button once. After a moment, the calculated length of
the cable will appear in the upper right hand corner of the screen.
8. The screen will display "Short" if the two conductors are directly
connected or have a low resistance connection between them.
The length will be shown up to the shorted point.
9. The screen will display "Open" if the two conductors are not
directly connected or have a high resistance connection between
them. This is the normal condition for performing length testing.
If there is an unexpected open condition along the length of the
cable, only the length up to that point will be displayed.
10. The screen will display "Error" and show dashes instead of the
length if an error condition has occurred. This could be because
the cable is improperly terminated or there has been excessive
signal loss.
• Using Loop Testing Mode:
The Ranger™ TDR can run continuous tests when set to Loop Mode.
Loop Mode can help when testing long cable runs susceptible to
signal loss, and enabling you to test multiple cables without having to
press the Test button each time.
1. While in Test Mode, press and hold the Test button.
2. The screen will momentarily fl ash "LOOP", then run a test every
two seconds and display the results.
3. Pressing any other button except the Power button exits
Loop Mode.
Obtaining NVP Values Obtaining NVP Values section.
Step 7
Step 10
Setting NVP Values Setting NVP Values section.
11