Ir Programming Port; Parameter Setting With Pc - ITALFARAD PFC144evo Manuel De Fonctionnement


The parameters of the PFC144evo regulator can be configured through the front optical port, using the IR-USB
programming dongle, or with the IR-WiFi dongle.

This programming port has the following advantages:
 You can configure and service the PFC144evo regulator without access to the rear of the device or having to open
the electrical panel.
 It is galvanically isolated from the internal circuits of the PFC144evo regulator, guaranteeing the greatest safety
for the operator.
 High speed data transfer.
 IP54 front panel protection.
 Limits the possibility of unauthorized access with device configuration since it is necessary to have the IR-USB or
IR-WI-FI dongles.

Simply hold the dongle up to the front panel, connecting the plugs to the relevant connectors, and the device will
be acknowledged as shown by the LINK LED on the programming dongle flashing green.

You can use the PFC Remote monitoring software to transfer (previously programmed) set-up parameters from the
PFC144evo regulator to the hard drive of the PC and vice versa.

The parameter may be partially transferred from the PC to the PFC144evo regulator, transferring only the
parameters of the specified menus.
Tel.+39 051 6618311 Fax +39 051 6605594 E-mail: italfarad@italfarad.com Web: www.italfarad.com

IR programming port

Parameter setting with PC

ITALFARAD S.p.A. via IV novembre n.1 Minerbio Bo Italy
E
N
43