Operating Modes; Man And Aut Modes; Man Mode - ITALFARAD PFC144evo Manuel De Fonctionnement

There are two possible operating modes, listed below:
 The icons AUT and MAN indicate the operating mode automatic or manual.
 To change the mode, press and hold the
 The operating mode remains stored even after removing and reapplying the power supply voltage.
E
 When the unit is in manual mode, you can select one of the steps and manually connected or disconnect it.
N
 In addition to the specific icon, the alphanumeric display shows MAN in order to highlight the manual mode
condition. Press
 While the display shows MAN, it is possible to select the step to be switched on or off. To select a step,
use the
 Press to activate or deactivate the selected step.
 If the selected step has not yet exhausted the reconnection time, the
transaction has been accepted and will be conducted as soon as possible.
 Manual configuration of the steps is maintained even when the power supply voltage is removed. When the power
returns, the original state of the steps is restored.
Tel.+39 051 6618311 Fax +39 051 6605594 E-mail: italfarad@italfarad.com Web: www.italfarad.com
to view the other measurements as usual.
or buttons. The selected step will flash quickly.
MAN
mode
icon
Tot kvar
inserited in
MAN
Select step
ITALFARAD S.p.A. via IV novembre n.1 Minerbio Bo Italy

Operating modes

MAN and AUT modes

or button for 1 sec.

MAN mode

Change step status
icon will flash to indicate that the
Connected
steps
Manual step
selection
enabled
38