VOLTCRAFT 1000 BASIC CH Mode D'emploi page 35

• Do not connect the product to the power supply
immediately after it has been transferred from a cold
room into a warm one (e.g., during transport). The
condensation that develops in such cases could
damage the device or cause an electric shock! Allow
the product to reach room temperature. Wait until
the condensation has evaporated. This might take
several hours. Only after this should it be plugged in
to the mains supply and put into use.
• Do not use the product if it is damaged. There is a
risk of a life-threatening electric shock!
• Switch off the mains socket to which the product is
connected (switch off at the corresponding circuit
breaker or remove the safety fuse, then switch off
the earth leakage circuit breaker). Then unplug the
product from the mains socket.
Do not use the product any longer, take it to a spe-
cialised workshop or dispose of in an environmentally
friendly manner.
Safe operation can no longer be assumed if:
- the product shows visible signs of damage
- the product does not work at all or works poorly
(leaking smoke or a smell of burning, audible
cracking noises, discolouration to the product or
the adjacent surfaces)
35