Intended Use - VOLTCRAFT 1000 BASIC CH Mode D'emploi

1. INTENDED USE

The product is used to measure and display the power consumption
of electric devices. The product is connected between the mains
socket and the electric consumer and requires no additional instal-
lation. Operation is only admissible when connected to a common
mains socket. The max. admissible power rating of the connected
consumer must not be exceeded (see chapter "Technical data").
A electricity tariff can be entered to calculate costs. The measuring
device can then calculate and display a cost forecast per day,
month and year.
The saved forecast data can also be displayed when not connected
to a mains socket since in this case the measuring device is supplied
with power by 2 batteries.
The measuring device is not officially calibrated and therefore must
not be used for billing purposes.
Please read the operating instructions carefully and do not discard
them. If you pass the product on to a third party, please hand over
these operating instructions as well. Observe all safety instructions
and information within this operating manual.
Any use other than that described above could lead to damage to
this product and involves risks such as short circuits, fire, electric
shock, etc. No part of the product may be modified or converted!
This product complies with the applicable national and European
requirements. All names of companies and products are the
trademarks of the respective owners. All rights reserved.
28