Electrolux SK23113 Notice D'utilisation page 70

70 www.electrolux.com
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the nat-
ural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The Af-
ter Sales Service specialist will carry out
the reversibility of the doors at your cost.
1 2
• Tighten the hinge.
• Put the top in position.
• Push front the top.
• Screw both screws on the rear side.
• Remove and install the handle (if fore-
seen) on the opposite side
• Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
3