Error Codes - Pioneer SGY-PM900H90 Mode D'emploi

Error codes

An error code is displayed if an error occurs while setting the crank length or doing calibrations.
Code Description of error
1 Parameter deviation (mass of load is 0)
Insufficient battery power
2
Failed to calibrate zero point (tangential and radial)
3
The zero point calibration is very different from the desired
4
value.
5 Not used
6 Large disruption detected due to vibration during calibration
Calibration with load was done before high accuracy zero point
7
calibration
8 Exceeded measurement limit during load calibration
Data (radial)
-
-
1: Error
0: Normal
Multiple of detected value of force Multiple of detected value of force
-
Degree of instability of detected
value of force
-
Multiple of detected value of force Multiple of detected value of force
Troubleshooting
Data (tangential)
-
-
1: Error
0: Normal
-
Degree of instability of detected
value of force
-
EN
53