Pioneer SGY-PM900H90 Mode D'emploi page 40

EN
Calibration
3
Tap [Send Crank Length] to send the length of the crank to the pedaling monitor sensors.
If the transmission is finished, "Done" appears in [Status] and "Success" appears in [Result].
4
Press the
5
Enter the mass of the weight and tap [Done].
• The mass (kg) of the weight and the confirmation number (three digits) are noted in the position shown in the diagram.
This completes the crank length and calibrating weight settings.
Next, do the calibrations with a load on the pedals.
40
(BACK) button to return to the previous screen and then tap [Weight for Calibration].
Confirmation number
Mass of weight