Calibration Preparations - Pioneer SGY-PM900H90 Mode D'emploi

Calibration Preparations

EN
To do the calibration correctly, put a load on the left side crank arm and twist the point where the sensor and the crank are in
contact.
•
This procedure is only necessary for the left side crank arm. Do this procedure before calibrating if you are using the power meter mode
also.
1
Mount the bicycle on a trainer or some other safe stand.
2
Point the left crank arm forward, and turn the rear wheel so the crank arm is parallel to the ground.
3
Lock the rear wheel with the rear brake, place your foot on the left pedal, and put your weight on it for
about 5 seconds.
Do not put your foot on the right pedal when doing this.
36