Pioneer SGY-PM900H90 Mode D'emploi page 46

EN
Checking the Calibration
7
Point the crank arm forward, rotate the rear wheel so the spirit level is horizontal and use the rear brake
to lock the rear wheel in place.
8
Confirm that the values that appear on the SGX-CA900 Force Preview are within the range shown below.
• Tangential Direction Force: (Confirmation number of calibration weight) ± 3 N
•
Radial Direction Force: 0 ± 3 N
• See page 40 regarding the confirmation number of calibration weight.
•
Adhesion may have failed if the values in the Force Preview continue moving for more than a minute as you check them.
Check the adhesive you are using and the adhesive's recommended hardening time and temperature while hardening.
9
Slowly loosen the rear brake to release the rear wheel.
10
Confirm that the values that appear on the SGX-CA900 Force Preview are within the range shown below.
•
Tangential Direction Force: 0 ± 3 N
• Radial Direction Force: (Confirmation number of calibration weight) ± 3 N
•
Adhesion may have failed if the values in the Force Preview continue moving for more than a minute as you check them.
Check the adhesive you are using and the adhesive's recommended hardening time and temperature while hardening.
11
Carefully remove the calibration weight, the calibration pedal bolt and the spirit level.
Checking the calibration of the right side is finished. Check the calibration of the left side in the same way.
46