entrematic Ditec E1A Manuel Technique page 38

11. Example of automation in parallel
A B
The automatic closing is obtained by regulating the TC trimmer not at the maximum, and in the
same position in both control panels.
BIXLR22
SWT
E1A A
i
NOTE: the opening and closing movements are not synchronised.
ATTENTION: in the absence of safety edges SOFA1-SOFA2, connect commands 1-6 and
1-8 to the SWT card.
It is possible to command two automations [A] and [B] side by side,
making the connections indicated in figure.
Commands 1-5 and the remote control (with DIP1=ON) are equivalent
to a total opening command.
To manage both automations with a single remote control, do not use
the radio receivers on the control panels, but insert a BIXLR22 receiver.
JR1 JR2
0 6 8 41 6 8 0 6 8 41 6 8
38
SWT
E1A B