5- Step Connection Preliminary Test; 6- Setup - ITALFARAD IFC7 Notice D'utilisation

If the unit has already been programmed, at feeding, after the selfdiagnostic, the unit
starts operating.
During the selfdiagnostic the display shows a count down (5-4-3-2-1).
5. Step connection preliminary test
If the unit has not been programmed yet (first installation) and the display shows " "
manual switching of the steps (relays) is possible through the keys or .
This function allows to check the wiring and the switching contactors.
6. Set up
Respect the following sequence to enter the SET UP. This procedure provides against
unauthorized modifications of data.
Select MANUAL mode operation and disconnect the step.
Press and keep pressed the key .
for 5 seconds until the LEDs "AUTO" and "MAN"
Press contemporary the key
start flashing.
The enter the parameters follow the indication table bellow.
Foward parameters
Save setting
Backwards parameters
Set parameters
Led indication (according to table below)
GB
ITALFARAD S.p .A. via IV novembre n.1 Minerbio (BO) It aly
19