Frequently Asked Questions; Foire Aux Questions - Weiser SmartCode 10 Guide D'utilisation

Problem
Problème
Lock doesn't operate correctly
after removing and replacing
the battery pack.
La serrure ne fonctionne pas
correctement après que le bloc de
piles est enlevée et remplacée .

FREQUENTLY ASKED QUESTIONS

FOIRE AUX QUESTIONS

ENGLISH
How long will the lock operate on a set of batteries?
Based on 10 operations per day, a single set of Alkaline batteries will operate the lock for over a year.
What type of batteries do you recommend?
For best results, use new non-rechargeable Alkaline batteries only.
I am planning to be away for several months; will my lock operate when I get back?
When the system is idling, it consumes minimum power (very close to battery shelf life.) With alkaline
batteries, the lock should be operable after years of idle.
I replaced my batteries less than a year ago and need to replace them again.
Check door alignment. If the SmartCode makes several attempts to lock or unlock the door, it may
mean that the door is warped and the latch does not line up correctly with the strike. Operating the
lock excessively reduces battery life. Avoid turning on the keypad light unnecessarily.
What settings should I use to get the maximum battery life out of my lock?
Set switches #1, #2, and #3 to the OFF position.
20
Reason
Raison pour
Incorrect initialization due to
remaining charge.
L'initialisation est incorrecte ou
incomplète en raison de la chargement
de la batterie.
Solution
Solution
Remove battery pack. Press
and hold the Program button for
10 seconds, then reinsert the
battery pack. If successful, the
LED will flash green and you will
hear a beep, indicating proper
initialization. If unsuccessful,
attempt this procedure again.
Retirez le bloc de piles. Appuyez sur le
bouton du programme et maintenez-le
appuyé pendant 10 secondes, puis
réinsérez le bloc-piles . Si c'est
réussi, le DEL clignotera en vert et
vous entendrez un bip, indiquant une
initialisation correcte. Sinon, refaites la
procédure.