Care And Cleaning - Atag VA6111MT Notice D'utilisation

24
• Put the light items in the upper basket.
Make sure that they do not move.
• Make sure that the spray arms can move
freely before you start a programme.
Using salt, rinse aid and detergent
• Only use salt, rinse aid and detergent for
dishwasher. Other products can cause
damage to the appliance.
• The rinse aid helps, during the last rinsing
phase, to dry the dishes without streaks
and stains.
• Combi detergent tablets contain deter-
gent, rinse aid and other added agents.
Be sure that these tablets are applicable
to the water hardness in your area. Refer
to the instructions on the packaging of
the products.
• Detergent tablets do not fully dissolve
with short programmes. To prevent de-
tergent residues on the tableware, we

Care and cleaning

Warning! Before maintenance,
deactivate the appliance and
disconnect the mains plug from the
mains socket.
Cleaning the filters
B
recommend that you use the tablets with
long programmes.
Before starting a programme
Make sure that:
• The filters are clean and correctly instal-
led.
• The spray arms are not clogged.
• The position of the items in the baskets is
correct.
• The programme is applicable for the type
of load and for the degree of soil.
• The correct quantity of detergent is used.
• There is dishwasher salt and rinse aid
(unless you use combi detergent tablets).
• The cap of the salt container is tight.
1. Turn the filter (A) counterclockwise and
C
A
2. To disassemble the filter (A), pull apart
3. Remove the filter (B).
A1
4. Wash the filters with water.
5. Put the filter (B) to its initial position.
A2
Do not use more than the correct
quantity of detergent. Refer to the in-
structions on the detergent packaging.
Dirty filters and clogged spray arms de-
crease the washing results.
Make a check regularly and, if neces-
sary, clean them.
remove it.
(A1) and (A2).
Make sure that it assembles correctly
under the two guides (C).