Bosch ZF 60 Instructions D'emploi page 16

Checking the Joint
too deep
Move template 3 to the front.
Turn adjustment knob 4 to
the rear.
not deep enough
Move template 3 to the rear.
Turn adjustment knob 4 to
the front.
not flush
Correct stop screws 9
too loose
Increase cutting depth
too firm
Reduce cutting depth
If interlocking on one side is too narrow, offset the stop screws 9 by the
same amounts to the inside or to the outside.
Finger Joining
Guide bush: Ø 13.8 mm
Straight bit: End-milling cutter Ø 10 mm
See "Tool Specifications" for the working ranges.
Install template 12 for finger joining and dowels (FS 20 =
accessory) with angle 21 so that the fingers point to the
front and align them (see "Aligning Template").
2 609 931 304 • 03.12
Setting Cutting Depth on Router
The cutting depth of the finger joints is equal to the material thickness.
Set depth stop and depth locking of router: Place the board to be ma-
chined horizontally on the base plate 16. Lower template 12. Place rout-
er next to the board on the template 12 and lower when switched off un-
til the router touches the base plate 16. Lock router. Take router from
template 12 and remove board.
Clamping a Backing Board (see Fig.
The backing board 27 prevents the workpiece edge from tearout during
machining.
Loosen both clamping levers 5 und 11.
Horizontally clamp an backup board 27 with a smooth front edge that
must be 5 mm thicker than the routing depth. The front edge must be
flush with the base plate 16. Tighten upper clamping bracket 2.
Lower template 12 and lock with locking levers 5 and 11.
Setting the Stop Screws 9
Loosen all four stop screws 9 and push them to the right or left edge.
Left stop: Place setting gauge 13 evenly on base
plate 16. Press right leg of setting gauge 13 to the left
against a finger of the template 12 and hold it. Push front
left stop screw 9 to the right against the setting gauge 13
and tighten it.
Right stop: Press left leg of setting gauge 13 to the right
against a finger of the template 12 and hold it. Push front
right stop screw 9 to the left against the setting gauge 13
and tighten it.
Note: It is recommended to make a test joint to check the setting of the
finger joining equipment.
English - 4
E
)