Makita AN930H Manuel D'instruction page 9

Choose and use nails so that the penetration amount
into concrete ranges 10 mm (3/8") - 15 mm (5/8") by
referring to the table below.
Wood thickness Nail length
30 mm(1-3/16") 45 mm(1-3/4")
35 mm(1-3/8") 50 mm(2")
50 mm(2") 65 mm(2-1/2")
013616
1
013615
CAUTION:
Use this tool only for soft concrete built up not so
•
long before. Using on the hard concrete may
cause nail bending or nailing to insufficient depth.
When the penetration amount into concrete comes
•
to more than 15 mm, nailing to the sufficient length
may not be obtained.
Cutting off the sheet
013454
CAUTION:
Always disconnect the hose before cutting off the
•
sheet.
Tear off the output sheet in the direction of the arrow
when using the sheet collated nails.
Jammed nailer
013455
Concrete range
10 mm(3/8") -15 mm(5/8")
10 mm(3/8") -15 mm(5/8")
10 mm(3/8") -15 mm(5/8")
1. Nail length
2. Wood thickness
3. Concrete range
10 mm (3/8") -
2
15 mm (5/8")
3
013456
CAUTION:
Always disconnect the air hose and remove the
•
nails from the magazine before cleaning a jam.
When the nailer becomes jammed, do as follows:
After depressing the latch lever and open the door, open
the magazine cap and remove the nail coil. Insert a
small rod or the like into the ejection port and tap it with
a hammer to drive out the nail jamming from the
ejection port. Reset the nail coil and close the magazine
cap.
MAINTENANCE
CAUTION:
Always disconnect the air hose from the tool
•
before attempting
maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Drain tool
Remove the hose from the tool. Place the tool so that
the air fitting faces down to the floor. Drain as much as
possible.
Cleaning of tool
Iron dust that adhere to the magnet can be blown off by
using an air duster.
Cap
013459
When not in use, disconnect the hose. Then cap the air
fitting with the cap.
9
to perform inspection
1. Cap
1
or