Hamron 604097 Mode D'emploi page 15

Regularly check that all the screw and electrical connections are correctly tightened. Tighten if
•
necessary. Remove any dirt or korrosion etc. from electrical connections.
Never attempt to open the winch, this will invalidate the warranty. Repairs must only carried out by
•
an authorised service centre.
• The gearbox is permanently lubricated at the factory with high-temperature lithium grease.
No internal parts need lubricating.
•
Replacing the wire
1. Engage by putting the clutch knob in the IN position.
2. Insert the wire in the wire holder. Firmly tighten the screw.
3. Run the winch to wind the wire on the drum.
IMPORTANT: Only use wires recommended by the manufacturer.
Problem
The motor does not work, or only
goes in one direction.
The motor runs but the drum
does not rotate.
The motor runs but not at full
power, or the drum rotates
slowly.
The motor overheats.
ENGLISH
MAINTENANCE
TROUBLESHOOTING
Possible cause
The remote control does not
work.
Broken wire or faulty connection.
Defective motor.
Disengaged position.
The battery is low.
Defective motor.
The winch has been run for too
long.
Defective motor.
15
Action
Replace the remote control.
Check the connections, and
clean if necessary.
Repair or replace the motor.
Engage.
Recharge or replace the battery.
Remove any corrosion from the
battery terminals.
Check the connections, and
clean if necessary.
Repair or replace the motor.
Allow the winch to cool at
intervals.
Repair or replace the motor.