Breville Barista Express Manuel D'instructions page 27

WARNING
Do not immerse power cord, power plug or
appliance in water or any other liquid.
USING THE ALLEN KEY
Over time, the silicone seal surrounding the
shower screen will need to be replaced to
ensure optimum brewing performance.
1. Press the POWER button to switch the
machine off and unplug the cord from the
power outlet.
2. Carefully remove the water tank and drip
tray, taking particular care if they are full.
3. Using a skewer or similar, clean the center
of the screw of any residual coffee.
4. Insert the shorter end of the Allen Key
into the center of the screw. Turn counter-
clockwise to loosen the screw.
Clean center of screw
before inserting Allen Key.
5. Once loosened, carefully remove and retain
the screw and the stainless steel shower
screen. Make note of the side of the shower
screen that is downwards. This will make
re-assembly easier. Wash the shower screen
in warm soapy water, then dry thoroughly.
6. Remove the silicone seal with your fingers
or a pair of long-nose pliers. Insert the
new seal, flat side first, so the ribbed side
is facing you.
7. Re-insert the shower screen, then the screw.
With your fingers, turn the screw clockwise
for 2-3 revolutions then insert the Allen Key
to tighten until the screw is flush with the
shower screen. Do not overtighten screw.
8. Re-insert the drip tray and water tank.
Contact Breville Consumer Support or visit
www.breville.com for replacement silicone
seals or for advice.
27