Publicité
Les langues disponibles
Les langues disponibles
(Fig. C, C1)
Switch
To turn the tool ON, hold it as shown in Figure C or C1 and
push the on/off switch
1
turn the tool OFF, pull the on/off switch back toward the
cord.
Fig. C
Fig. C1
Operation
Grasp product as shown in Fig. C or C1 and turn it on. nOTE:
Do not rest fingers on platen during use. Move it in long
sweeping strokes across the surface, letting it do the work.
Light pressure is all that is required for sanding, polishing or
scrubbing. Excessive pressure will slow the tool and produce
inferior results. Check your work often, product is capable of
removing material rapidly.
WARNING: Shock hazard. Under no circumstances
should this product be used near water.
CAUTION: To reduce the risk of injury, turn off and
unplug the tool before making any adjustments or
removing or installing attachments or accessories.
Detail Sanding
Your tool is equipped with a teardrop base which allows
you to use it on large flat surfaces and tight spots or corners.
The pad tips may wear unevenly, depending on use.
Fitting sanding sheets (Fig. D)
1. Hold the tool with the sanding pad
2. Place the sanding sheet onto the sanding base, ensuring
all the holes of the paper line up with the holes in the
sanding pad as shown in Fig. D.
Fig. D
toward the front of the tool. To
1
5
facing upward.
Finger Attachment (Fig. E)
The finger attachment is used for fine detail sanding.
1. Remove the screw.
2. Remove the diamond-shaped pad tip
3. Fit the finger attachment onto the sanding base as
shown in Fig. E.
4. Fit and tighten the screw.
5. Align the proper sanding sheet with the finger
attachment.
Fig. E
Dust Extraction (Fig. F)
To Empty Dust Canister:
CAUTION: Respiratory hazard. Never operate this tool
for wood sanding unless the dust canister is in place.
Sanding dust exhaust may create a breathing hazard.
WARNING: Fire hazard. Collected sanding dust from
sanding surface coatings (polyurethane, linseed
oil, etc.) can self-ignite in sander dust canister or
elsewhere and cause fire. To reduce risk, empty
canister frequently and strictly follow sander manual
and coating manufacturer's instructions.
WARNING: Fire hazard. When working on metal
surfaces, do not use the dust canister or a vacuum
cleaner because sparks are generated. Wear safety
glasses and a dust mask. Due to the danger of fire, do
not use your sander to sand magnesium surfaces. Do
not use for wet sanding.
The dust collection canister
10 minutes of sanding.
1. While holding the sander, grasp the dust collection
canister and pull it off of the sander as shown in Fig. F.
2. Hold the canister just inside a garbage can to ensure
dust is contained.
3. Push up on tab
from the bottom as shown in Fig. F.
Fig. F
5
4. Gently shake or tap the top and bottom of the canister
to empty.
6
from the base.
6
4
should be emptied after every
8
to separate the top of the canister
8
4
English
7
5
Publicité
