Philips GC9500 Mode D'emploi page 11

Problem
The ironing board
cover becomes
wet.
Water droplets
come out of the
soleplate.
Steam and/or
water comes out
from under the
EASY DE-CALC
knob.
Dirty water
and impurities
come out of the
soleplate.
The iron leaves a
shine or an imprint
on the garment.
The steam
generator does
not produce any
steam.
The steam
generator
produces a
pumping sound.
4239_000_8457_3_DFU_Booklet_Luxury.indd 11
Possible cause
Steam has condensed on the
ironing board cover after a
long ironing session.
The steam that was still present
in the hose has cooled down
and condensed into water.
The EASY DE-CALC knob is
not tightened properly.
Impurities or chemicals
present in the water have
deposited in the steam vents
and/or on the soleplate.
Too much scale and minerals
have accumulated inside the
steam generator.
The surface to be ironed was
uneven, for instance because
you were ironing over a seam
or a fold in the garment.
There is not enough water in
the water tank (the 'water tank
empty' light flashes).
The steam generator is not
hot enough to produce steam.
You did not press the steam
trigger.
The water tank is not placed
properly in the steam
generator.
Water is pumped into the
boiler inside the steam
generator. This is normal.
Solution
Replace the ironing board cover if the foam
material has worn out. You can also add an extra
layer of felt material under the ironing board cover
to prevent condensation on the ironing board.
Point the iron away from the garment and let it
produce steam for a few seconds.
Switch off the appliance and wait for two hours
for steam generator to cool down. Unscrew the
EASY DE-CALC knob reattach it properly. Note:
When you remove the knob, water comes out
of the steam generator. If steam continues to
escape, switch off the appliance and contact an
authorised Philips service centre.
Descale the steam generator regularly. See
section 'Cleaning the soleplate' in chapter
'Cleaning and maintenance'.
Descale the steam generator regularly.
See section 'IMPORTANT - Descaling the steam
generator' in chapter 'Cleaning and maintenance'.
Perfect Care is safe on all garments. The shine or
imprint is not permanent and will come off if you
wash the garment. Avoid ironing over seams or
folds or you can place a cotton cloth over the
area to be ironed to avoid imprints.
Fill the water tank.
Wait until the 'iron ready' light on the iron lights
up continuously.
Press the steam trigger and keep it pressed while
you iron.
Slide the water tank firmly back into the steam
generator ('click').
If the pumping sound continues nonstop, switch
off the steam generator and remove the plug
from the wall socket. Contact an authorised
Philips service centre.
ENGlIsh
11
7/5/13 1:38 PM