Philips AT940 Mode D'emploi page 8

English
8
and not dangerous because all electronics are
enclosed in a sealed power unit inside the shaver.
- Do not use the shaver, adapter or charging
stand (AT940 only) if it is damaged, as this
may cause injury. Always replace a damaged
adapter or charging stand with one of the original
type.
- Charge and store the appliance at a temperature
between 10°C and 35°C.
- Always place and use the shaver and the charging
stand (AT940 only) on a surface that is fluid-
resistant.
- Only use the adapter and the charging
stand (AT940 only) supplied.
- Always put the protection cap on the shaver
to protect the shaving heads when you are
travelling.
- If the shaver is subjected to a major change
in temperature, pressure or humidity, let
it acclimatise for 30 minutes before you use it.
Compliance with standards
- This shaver complies with the internationally
approved safety regulations and can be safely used
in the bath or shower and cleaned under the tap.
- This Philips appliance complies with all standards
regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this
user manual, the appliances are safe to use based
on scientific evidence available today.
general
- The appliance is equipped with an automatic
voltage selector and is suitable for mains voltages
ranging from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe
low voltage of less than 24 volts.