Philips AT940 Mode D'emploi page 11

- AT893/AT890/AT753/AT752/AT750: When the
battery is fully charged, the charging light lights up
green continuously.
Note: After approx. 30 minutes, the charging light goes
out to save energy.
Charging with the adapter
1 Put the small plug in the shaver.
2 Put the adapter in the wall socket.
, The charging light shows the charging status of
the shaver (see section 'Charge indications' in
this chapter).
Charging in the charging stand (AT940 only)
1 Put the small plug in the charging stand.
2 Put the adapter in the wall socket.
3 Place the shaver in the charging stand.
, The charging light shows the charging status of
the shaver (see section 'Charge indications' in
this chapter).
Using the shaver
Note: This shaver can be used in the bath or shower. It
can therefore not be used directly from the mains for
safety reasons.
shaving tips and tricks
- This shaver is suitable for both wet and dry use.
Use the shaver with shaving gel or foam for extra
skin comfort, or use the shaver dry for extra
convenience.
English
11