Philips AT940 Mode D'emploi page 21

Problem
The shaver does
not shave as well
as it used to.
The shaver does
not work when I
press the on/off
button.
Troubleshooting
This chapter summarises the most common
problems you could encounter with the appliance. If
you are unable to solve the problem with the
information below, contact the Consumer Care
Centre in your country.
Possible cause
The shaving
heads are
damaged or
worn.
Foam or gel
residues clog
up the shaving
heads.
Long hairs
obstruct the
shaving heads.
You have not
inserted the
shaving heads
properly.
The
rechargeable
battery is
empty.
Solution
Replace the shaving heads (see
chapter 'Replacement').
Rinse the shaving unit under a
hot tap (see section 'Cleaning
the shaving unit under the
tap' in chapter 'Cleaning and
maintenance').
Clean the shaving heads one by
one (see section 'Cleaning the
shaving unit with the cleaning
brush' in chapter 'Cleaning and
maintenance').
Make sure that the projections
of the shaving heads fit exactly
into the recesses (see section
'Cleaning the shaving unit with
the cleaning brush').
Recharge the battery (see
chapter 'Charging').
English
21