Pentair Jung Pumpen COMPLI 1535/2 B2 HL Instructions De Service page 19

INFORMATION
• Operating hours
Displays the operating hours per pump and the pump
switching cycles
• Event memory
Shows the error messages of the system. The newest mes-
sage is at the top, older ones below. After 70 messages, the
oldest message is deleted from the memory.
• Level control
Displays the level control system that is set
• Max. runtime
Displays the running time limit that has been set for the
pumps (S2/S3 time)
• Follow-up Time
Displays the follow-up time that has been set for static
pressure systems
• Start delay
Display the period of time that has been set between sup-
plying power supply and being operational
• Test run
Displays whether the test run is activated
• Auto draining
Displays the interval that has been set for the automatic
pumping procedure in analogue systems, to prevent long
stationary periods
• Acoustic alarm
Displays whether the buzzer is activated
• Alarm relay pulsing
Shows whether the relay works in cycles in the event of an
alarm or whether it is continuously energised
• Alarm delay
Shows currently set delay for alarm relay
• AUX alarm
Shows whether the signalling is switched on or off
• AUX logic
Shows whether the auxiliary input works as an NC contact
or an NO contact
• AUX influence
Shows, what influence the auxiliary input as on the pumps
• Phase seq. monitor
Shows whether the check on the direction of rotation is
activated
• P1 current limit
Shows the current limitation that has been set for pump 1
• P2 current limit
Shows the current limitation that has been set for pump 2
• Battery voltage
Displays the voltage of the 12 V battery (only with accessory
RTC module)
• Maintenance service
Call number of the responsible customer service
• SW Version
Shows the current software version
ENGLISH
19