Checking The Chain Brake; Checking The Oil Automatic System - Deltafox DG-ECS 1830 Traduction De La Notice D'utilisation Originale

GB
1. Release the chain brake, where
you shift the brake arm (4) back
against the front grip.
2. Form a loop from the end of the
extension cable and hang this
into the tension relief (19) on the
rear grip.
3. Connect the device to the mains
voltage.
4. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear grip and the left
hand on the front handle. Thumb
and finger must close securely
over the handles.
5. For switching on, activate the
switch-on block (12) with the right
thumb and then press the On/
Off switch (11), the electric power
saw runs with highest speed.
Release the switch-on block
again.
6. The power saw switches off
when you release the On/Off
switch again. Switching for con-
tinuous running is not possible

Checking the chain brake

The saw chain does not turn if
the chain brake is engaged.
1. Release the chain brake by
shifting the brake arm (4) over
against the front grip.
2. Place the electric chainsaw onto
a solid, flat surface. It must not
contact any objects.
3. Connect the device to the mains
voltage.
4. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear grip and the left
hand on the front handle. Thumb
38
and finger must close securely
over the handles (see
5. Turn on the electric chainsaw.
(See "Switching On").
6. Activate the chain braking lever
(4), with running motor, with the
left hand. Chain should stop
abruptly..
7. Once the chain brake is work-
ing properly, release the on/off
switch and the chain brake.
If the chain brake does not func-
tion correctly, you must not use
the electric chainsaw. A slack
saw chain leads to danger of in-
jury.
Return the electric chainsaw to
our Service-Center for repair

Checking the oil automatic system

Check the oil level and the oil automatic
system before commencement of work.
• Switch on the chainsaw and hold it
above a bright background. The saw
must not touch the ground.
If an oil trace can be seen, the chainsaw
is working trouble-free.
Oils can become viscous in cold
weather.
If no trace of oil appears, it may
be necessary to clean the oil out-
let channel or to have the electric
chainsaw repaired by our cus-
tomer service.
).