Timer Operation; Heat Mode - Sharp AY-XPM7FR Mode D'emploi

TIMER OPERATION

NOTE:
Before setting the timer, make sure the clock is properly set with the current time.
TIMER OFF
DISPLAY
MODE 1h
CLEAN
FAN
SWING
SET/C
TIPS ABOUT TIMER OFF OPERATION
When the TIMER OFF mode is set,
the temperature setting is automati-
cally adjusted to prevent the room from
be coming excessively hot or too cold
while you sleep. (Auto Sleep function)
COOL/DRY MODE:
• One hour after the time operation begins,
the temperature setting rises 1°C higher
than the original temperature setting.

HEAT MODE:

• One hour after the timer operation begins,
the temperature setting drops 3°C lower
than the original thermostat setting.
1
Press the TIMER OFF (
2
The TIMER OFF indicator will blink; press
the TIME ADVANCE or REVERSE buttons to
set the desired time. (The time can be set in
10-minute increments.)
3
Point the remote control at the signal receiver
window on the unit and press the TIMER SET
(SET/C) button.
• The orange TIMER lamp (
light.
• The unit will generate a beep when it receives the
signal.
1
2
3
TO CANCEL TIMER MODE
Press the TIMER CANCEL (SET/C) button.
• The orange TIMER lamp (
turn off.
• The current clock
time will be displayed
on the remote con-
trol.
NOTE:
• If any TIMER ON, TIMER OFF and 1-HOUR
OFF TIMER are set, the TIMER CANCEL but-
ton cancels all settings.
TO CHANGE TIME SETTING
Cancel the TIMER setting fi rst, then set it
again.
GB-14
) button.
) on the unit will
) on the unit will
MODE 1h
CLEAN
FAN
SWING
SET/C