Sharp XL-1000V Mode D'emploi page 11

„ Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM
75 OHMS socket and position the FM
aerial wire in the direction where the
strongest signal can be received.
Supplied AM loop aerial:
Connect the AM loop aerial wire to the
AM and GND terminals. Position the
AM loop aerial for optimum reception.
Place the AM loop aerial on a shelf,
etc., or attach it to a stand or a wall with
screws (not supplied).
Notes:
z Placing the aerial on the unit or near the AC power lead may
cause noise pickup. Place the aerial away from the unit for better
reception.
z When static is still heard even after adjusting the position of the
AM loop aerial, try reversing the wire connections.
Installing the AM loop aerial:
< Assembling >
External FM or AM aerial:
Use an external FM or AM aerial if you require better reception.
Consult your dealer.
External
External AM aerial
FM aerial
15 m (49 feet)
7.5 m (25 feet)
Earth rod
< Attaching to the wall >
Wall Screws (not supplied)
AM loop aerial
Notes:
z When an external FM aerial is used, disconnect the supplied FM
aerial wire from the FM 75 OHMS socket.
z When using an external AM aerial, be sure to keep the wire of the
AM loop aerial connected.
„ Speaker connection
Connect the black wire with white dots to the minus (-) terminal and
the black wire to the plus (+) terminal.
Caution:
z Connect the speaker wires to the speakers first, then to the
unit.
z Use speakers with an impedance of 8 ohms or more, as lower
impedance speakers can damage the unit.
z Do not mistake the right and the left channels. The right speaker
is the one on the right side when you face the unit.
z Do not let the bare speaker wires touch each other.
Incorrect
XL-1000V
Incorrect
ENGLISH E-10