General; Pointers; Scope Of Guarantee; Safety Instructions - Ecolab MULTRONIC Manuel Technique

1

General

This technical manual contains all instructions necessary for the installation, start-up and
maintenance of the measuring and control unit MULTRONIC / timer module. All information
on the basic device can be found in the main part of the operating manual.
The timer module can only be employed in Multronic devices with special
desalination software and in connection with a desalination module (inductive or
conductive).
The German sections of this manual constitute the ORIGINAL OPERATING MANUAL and
NOTE
take legal precedence.
All other languages are translations of the ORIGINAL OPERATING MANUAL.
The safety instructions and pointers must always be observed!
1.1

Pointers

In this manual, the CAUTION, ATTENTION and NOTE pointers have the following
meanings:
CAUTION
ATTENTION
NOTE
1.2

Scope of guarantee:

The manufacturer only accepts the guarantee with regard to the operating safety and
reliability under the following conditions:
- Assembly, connection, adjustment, maintenance and repairs are carried out by
authorised, qualified personnel.
- The measuring unit is used in accordance with the instructions in the technical manual.
- Only original spare parts are used for repairs.
1.3

Safety instructions

The unit has been built and tested in accordance with the relevant protective measures for
electronic units and was free of safety defects when it left the factory. To ensure that this
remains the case and to guarantee safe operation, it is essential that the user observes the
instructions and warnings contained in this manual. If there are any causes to suspect that
the unit can no longer be operated free of hazard, the unit should be shut down and
secured against inadvertent operation.
It is the case when:
- The unit shows visible signs of damage.
- The unit does not seem to be functioning properly.
- The unit has been stored for lengthy periods of time under unfavourable conditions.
CAUTION
ATTENTION
NOTE
417101824_Anhang13_Timermodul.doc
This heading is used if imprecise or non-adherence to operating instructions, work
instructions, prescribed work procedures and the like can lead to injury or accident.
This heading is used if imprecise or non-adherence to operating instructions, work
instructions, prescribed work procedures and the like can lead to the device being
damaged.
This heading is used if a special feature is being pointed out.
The unit and its associated accessory components (e.g. electrodes, recording units
etc.) must be installed in accordance with the relevant safety provisions.
The installation site must be chosen such that the housing is not exposed to any major
mechanical loadings.
Prior to starting-up, it is essential to check that all parameters have been correctly set.
Timer Modul
- 11 - Rev.: 4-07/10