Zones: Schedule And Notification - Abus TVVR35010 Manuel Utilisateur

Device menu
3. Select "Advanced" to specify the other camera set-
tings.
"Advanced" tab
Camera
Image Settings
Mask
Tamper Detection
Motion Detection
Video Loss Detection
Copy To

Zones: Schedule and notification

Note
You can assign the surveillance parameters indi-
vidually and control the notification type for tamper
monitoring, motion detection and video loss detec-
tion.
Schedule
1. Select Schedule in the advanced camera settings.
38
Setting
Selection of the camera
No settings possible
No settings possible – settings
made inside of IP camera
Settings made inside of IP
camera – here you can set
how the DVR will handle an
alarm
Settings made inside of IP
camera – here you can set
how the DVR will handle an
alarm
Activation according to the de-
finable schedule and notifica-
tion (display, acoustic alarm,
notification of surveillance
centre, e-mail, trigger of an
alarm output)
Copies the settings
2. Select the day and enter the schedule.
Note
You can define up to 8 time periods (each from
00:00 to 00:00). The times in the individual peri-
ods must not overlap.
3. Select whether the settings should be applied to all
days of the week using Copy To and confirm with
Copy.
4. Exit the settings by pressing OK.
Notification
1. Select Handle in the advanced camera settings.
2. Enter the notification type:
Parameter
Pop-up Image on Moni-
tor
Audio Warning
Notify Surveillance Cen-
tre
Send Email
Trigger Alarm Output
3. Click on Apply to accept the settings.
4. Click on OK to exit the menu.
Setting the network camera
Notification
Message appears on moni-
tor
The device emits a repeat-
ing tone
See page 48
An e-mail is sent to a spe-
cific e-mail address (see
page 48)
See page 52