System operation
General information
The device can be controlled as follows:
•
Using the operating elements on the front of the de-
vice
•
Using the remote control
•
Using the USB mouse
Operating elements on the device
Note
Pay attention to the overview on page 3.
No.
Name
Function
1
USB port
•
To connect a USB mouse
•
To connect a USB stick for data backups
Power LED
2
Lights up blue when the system is switched on
3
IR receiver
For the remote control
4
REC LED
Lights up red during recording
5
HDD LED
Flashes blue when the HDD is accessed
6
Network LED
Lights up red when the network is accessed
7
Alarm LED
Lights up red in the event of an alarm
Connections on the rear of the device
Note
Pay attention to the overview on page 3.
No.
Name
Function
8
USB port
•
To connect a USB mouse
•
To connect a USB stick for data backups
9
VIDEO OUT: BNC monitor output
10
AUDIO IN: Cinch audio input
AUDIO OUT: Cinch audio output
11
LAN:
10/100 MBit Ethernet LAN connection
12
VGA: VGA monitor output
13
ALARM IN:
•
Alarm input 1–4
•
G = Ground
ALARM OUT:
•
Relay output and ground
14
12 V DC power socket
15
Power switch
16
Connection for grounding
Note
All audio inputs have no audio amplifier -> the au-
dio signal has to be amplified before connected.
Therefore you can use a microphone amplifier.
System operation
13