Pattern Settings - Abus TVVR35010 Manuel Utilisateur

PTZ control
Tour Settings
Patrols are defined tours from position to position that are
accessed in sequence on the PTZ camera. The individual
positions are presets, which should be set as detailed
above. The cameras can then each be moved in se-
quence to the corresponding positions at a defined
speed, where they remain for a set period of time.
Setting a tour within the DVR
Select the camera in the control panel, then click on "Pa-
trol Settings" in the pop-up menu:
1. Activate the patrol number.
2. Select an active, set preset from the list by checking
the box.
3. Click on "Set".
4. Set the key point number, duration and speed.
•
KeyPointNo.: Sequence
•
Duration: Time that the PTZ camera waits at a posi-
tion (in seconds)
•
Speed (0–7): Speed of camera movement
5. Accept the settings by pressing "Add".
6. Repeat steps 1–5 to define further patrols.
7. Exit the settings by pressing OK.
Note
A patrol consists of at least two preset positions.
You can set several patrols for one camera.
The set patrol can be tested as follows:
Click on "Start" and monitor the patrol. You can
stop the patrol at any time and repeat the patrol
settings (e.g. to make corrections).
28

Pattern Settings

Patterns are defined tours from position to position that
are accessed in sequence on the PTZ camera. Patterns
are recorded live. The system saves the parameters
used whilst you move and adjust the cameras in se-
quence to the corresponding positions at a defined
speed.
•
Select the camera in the control panel, then click on
"Pattern Settings" in the pop-up menu:
1. Select the pattern number.
2. Click on "Run Record" to start the pattern recording.
3. Using the control panel, adjust the camera position
and settings that you wish to record as a pattern.
4. The recording is made until "Stop Record" is clicked.
Note
•
Start the recorded pattern by calling up the
pop-up menu (right-click in the live view of the
PTZ camera).
•
Click on "Run Pattern" and click on the desired
pattern. The PTZ camera now starts moving to
the individual positions. After running through
the entire pattern, the process is started again.