Benning MM P3 Notice D'emploi page 24

40 V
400 V
600 V
The measured value of the BENNING MM P3 is obtained by mean value rectification
and is displayed as r.m.s. value.
The measuring accuracy is specified for a sinusoidal curve. In case of non
*1
sinusoidal curves, the accuracy of the displayed value decreases.
7.3 Resistance measuring range (Switch setting: Ω,
Overload protection for resistance measurements: 600 V
Measuring range
400 Ω
4 kΩ
40 kΩ
400 kΩ
4 MΩ
40 MΩ
7.4 Diode and continuity test (Switch setting: Ω,
Overload protection: 600 V
The integrated buzzer sounds at a resistance R lower than 50 Ω.
Measuring range
7.5 Capacity ranges (Switch setting:
Conditions: Discharge capacitors and apply them according to the specified polarity.
Overload protection for capacity measurements: 600 V
Measuring range
50 nF
500 nF
5 µF
50 µF
100 µF
The measuring duration depends on the capacitor size and might take up to 20 seconds.
* The measuring accuracy is specified for measured values from 10 nF and for pre-
vious null balance by means of the „RANGE/ REL Δ (
12/ 2007
10 mV ± (0.9 % of the measured value + 5 digits)
100 mV ± (0.9 % of the measured value + 5 digits)
1 V ± (1.5 % of the measured value + 5 digits)
Resolution
0.1 Ω ± (0.9 % of the measured value + 5 digits)
1 Ω ± (0.9 % of the measured value + 2 digits)
10 Ω ± (0.9 % of the measured value + 2 digits)
100 Ω ± (0.9 % of the measured value + 2 digits)
1 kΩ ± (1.5 % of the measured value + 5 digits)
10 kΩ ± (1.5 % of the measured value + 5 digits)
eff
Resolution
1 mV
Resolution
10 pF
100 pF
1 nF
10 nF
100 nF
BENNING MM P3
Measuring accuracy
Max. measuring current
1.1 mA
)
Measuring accuracy
± (5.0 % of the measured value + 0.2 nF)*
± (2.9 % of the measured value + 5 digits)
± (2.9 % of the measured value + 5 digits)
± (2.9 % of the measured value + 5 digits)
± (2.9 % of the measured value + 5 digits)
,
)
eff
Max. open-circuit
,
)
Max. opencircuit voltage
1.5 V
eff
)" key 6

600 V
eff
600 V
eff
600 V
eff
voltage
0.4 V
0.4 V
0.4 V
0.4 V
0.4 V
0.4 V
24